1998 Mercedes-benz Vito

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Brake load sensing valve linkage seized (3.6.E.3)

Emissions not tested (7.0)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Body has slight corrosion (6.1.B.2)

Offside Body has slight corrosion (6.1.B.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Horn not working (1.6.2a)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

offside inner cv joint bolt missing

both front tyres worn on inner edges

nearside handbrake performance low

play in steering rack nearside

Centre Exhaust mounting missing (7.1.1b)

Emissions not tested (7.0)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)

Fuel cap/sealing device sealing washer missing (7.2.4c)

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Nearside Outer Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high (1.8)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Inner Track rod end ball joint has slight play (2.2.B.1f)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear Brake pipe slightly corroded (3.6.B.2c)

nearside inner c.v. boot adrift