1997 Land Rover Discovery

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced lower footwell on bulkhead (6.1.1 (c) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Brake performance unable to be tested pads worn out (1.2.1 (g))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear fog lamp missing (4.5.1 (a) (ii))

Registration plate does not conform to the specified requirements front on dash wiper in way (0.1 (d))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Steering column has excessive movement up and down lower bearing (2.2.2 (a))

Steering column universal joint insecure column intermediate shaft loose at steering box (2.1.3 (a) (i))

Steering component casing fixing holes in chassis elongated panhard rod loose at axle end (2.1.2 (b) (i))

Suspension component ball joint excessively worn rear axle A frame ball joint (5.3.4 (a) (i))

Electrical wiring likely to touch hot or rotating parts wire from alternator touching exhaust (4.11 (a) (iii)) DANGEROUS

Offside Front Wheel bearing play so excessive that directional control is impaired (5.1.3 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced lower footwell on bulkhead (6.1.1 (c) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt both on track rod and both on drag link (2.1.3 (g) (i))

exhaust noisy

external rollcage

vehicle built for off-road use

vehicle suspension lifted

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front wheel bearing has slight play (2.5.A.3c)

advise n/s and o/s front body mounts corroded

1 n/s/r brake disc correded

2 slight play o/s/f wheel bearing

3 rear prop shaft coupling starting to split.

4 engine oil leak

Nearside Body or chassis is damaged, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Headlamp aim too low (1.8)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.C.1b)

Service brake: efficiency below requirements (3.7.C.1a)

1 n/s/r brake disc correded

2 slight play o/s/f wheel bearing

3 rear prop shaft coupling starting to split.

4 engine oil leak

Coolant leak

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Oil leak

n/s inner wing coroded outside prescribed area

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Brake pipe inadequately clipped (3.6.B.1)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.C.1b)

Registration plate lamp not working (1.1.C.1d)

Coolant leak

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Oil leak

n/s inner wing coroded outside prescribed area

1 play in front wheel bearings. 2 oil around hand brake drum (good hand brake readings) 3 corrosion to o/s inner wing not stress loading.

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Registration plate lamp not working (1.1.5c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

The rear propshaft doughnut deteriorated.The new brake pipes fitted would benefit with some more supports.The offside front tyre inner shoulder wearing thin.

The steel brake pipes across the rear axle surface corrosion present.Oil is appearing out of the parking brake drum assembly.The rear mounting points to the body starting to show signs of corrosion forming

Nearside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Child seat fitted not allowing full inspection of adult belt

The offside front tyre is wearing thin on the inner shoulder.The doughnut to the rear propshaft is deteriorating

The screen washers incorrectly adjusted.The offside front inner wing is excessively corroded within a prescribed area,but is not supportive to the component.

The steel brake pipes to the rear wheel expanders have some light surface corrosion present

Emissions not tested (7.0)

Rear Exhaust has a major leak of exhaust gases (7.1.2)