1997 Suzuki Vitara

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Headlamp aim too low Both fronts (4.1.2 (a))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer side sill behind plastic seal cover (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross frame (5.3.6 (a) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced cross frame (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer side sill behind plastic seal cover (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch section (5.3.6 (a) (i))

Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Both sides upper side corner sections (6.2.2 (d) (i))

Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Shock absorbers has an excessively worn bush Both rear lower (5.3.2 (c))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Rear Prop shaft joint worn, but not excessively (6.1.7 (c) (i))

Front Exhaust has a minor leak of exhaust gases back of CAT pipe joint (nearside) (6.1.2 (a))

Fuel Pipe/s corroded ()

Lower Steering column universal joint has slight wear or play (2.2.2 (c))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Suspension component pin or bush slightly worn Both rear trailing arm front and rear bushes (5.3.4 (a) (i))

Towbar slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Tyre slightly damaged/cracking or perishing Both rears (5.2.3 (d) (ii))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Offside Front Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

underbody corroded

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

underbody corroded

temp fuel cap fitted.

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill holed (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill holed (6.1.B.2)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Inner Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Inner Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Inner Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)