2007 Chrysler Pt Cruiser

Power steering pipe/hose has slight seepage steering rack (2.1.5 (a))

Central Front Fluid leak, but not excessive steering rack (8.4.1 (a) (i))

Emissions unable to be completed exhaust blowing at joints (8.2.1.2 (d))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Central Front Fluid leak, but not excessive steering rack (8.4.1 (a) (i))

Central Front coolant leak at bottom of radiator

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material slight rusting of brake pipes (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Brake pipe corroded, covered in grease or other material slight rusting of brake pipes (1.1.11 (c))

Exhaust has a minor leak of exhaust gases center joint (6.1.2 (a))

Offside Front tyre worn on the inner edge

Nearside Rear All direction indicators slightly discoloured (4.4.3 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing heavily perished advise attention (5.2.3 (d) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear All direction indicators slightly discoloured (4.4.3 (a))

Offside Rear Tyre slightly damaged/cracking or perishing heavily perished advise attention (5.2.3 (d) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Tyre slightly damaged/cracking or perishing nearside front slightly damaged and all tyres perishing (5.2.3 (d) (ii))

brake bind n/s/f advise attention

Position lamp not working both o/s/r & n/s/r (4.2.1 (a) (ii))

Position lamp not working both o/s/r & n/s/r (4.2.1 (a) (ii))

brake bind n/s/f advise attention

Offside Front lower engine mount has slight play

front brake application uneven (3.7.B.2)

Offside Headlamp aim too high (1.8)

Offside Stop lamp not working (1.2.1b)

Rear Exhaust system not adequately supported (7.1.1)

Rear Passenger's seat cannot be secured in the upright position. both (6.2.A.2)

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

both front arm rear bushes starting to split