2006 Subaru Impreza

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Fluid leak, but not excessive washer fluid (8.4.1 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive n/s+o/s inner sills (5.3.6 (a) (i))

Offside Front Brake hose slightly damaged (1.1.12 (b) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

front brake disc's corroded

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)