2005 Mazda Bongo

Front Brake pad(s) wearing thin both front pads (1.1.13 (a) (ii))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension rod ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Under Side Of Vehicle Corroded

Under Tray Fitted

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Under Side Of Vehicle Corroded

Under Tray Fitted

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases silencer (6.1.2 (a))

Exhaust system in poor condition

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive transmission (8.4.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive o/s and n/s spring mount areas (5.3.6 (a) (i))

Under side of vehicle corrosion o/s and n/s inner and outer sill holed

Brake pedal wearing smooth (1.1.2 (c))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside inner sill corroded

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside inner sill corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Passenger seat(s) missing at time of test

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Steering column attachment defective UJ seized - steering affected (2.2.2 (d) (i))

Brake pedal wearing smooth (1.1.2 (c))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside inner sill corroded

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside inner sill corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Passenger seat(s) missing at time of test

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

offside front inner sill has corrosion

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

front lower cross member corroded

undertray(s) fitted

Headlamp aim not tested (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

front lower cross member corroded

undertray(s) fitted

Brake pedal wearing smooth (1.1.2 (c))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside inner and outer sill corroded

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside inner and outer sill corroeded

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Fog lamp lens damaged

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Outer sill holed

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Outer sill holed

Oil leak, but not excessive (8.4.1 (a) (i))

o/s outer sill corroded

o/s/r tyre wearing low

play to prop shaft UJ

wipers slightly smearing

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear tyre cracking/perished slightly

Rear Exhaust has a minor leak of exhaust gases tail pipe broken (7.1.2)

Nearside Rear Tyre has ply or cords exposed cracking In tread (4.1.D.1b)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill panel (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Exhaust has a minor leak of exhaust gases center exhaust silencer has a slight blow (7.1.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases silencer tail pipe broken (7.1.2)

off side rear tyre has some cracking in the tread

All position lamps not working (1.1.A.3b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)