2011 Mazda Bongo

Front Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Headlight lenses deteriorated

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Tyre worn close to legal limit/worn on edge Worn inner edge (5.2.3 (e))

Offside Rear Inner/outer sill corroded

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both nearside and offside (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Trailer electrical socket wiring insulation damaged or deteriorated (4.10 (b) (i))

nsr hub seal leaking

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Trailer electrical socket wiring insulation damaged or deteriorated (4.10 (b) (i))

nsr hub seal leaking

stering rack damp

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

stering rack damp

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Fuel system component leaking pump (6.1.3 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Upper Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Nearside Rear Upper Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Rear registration plate insecure (6.3.1b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint o/s/f and o/s/r drop links (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement and o/s/r (d bushes) (2.4.G.2)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)