1998 Mazda 626

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nail in offside rear tyre

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear wiper blade split

Emissions not tested (7.0)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front brake disc slightly pitted (3.5.1h)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Rear registration plate character(s) not correctly formed (6.3.4b)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front brake disc slightly pitted (3.5.1h)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Front registration plate insecure (6.3.1b)

Rear Registration plate lamp not working (1.1.5c)

Small damage to rear seatbelt

Nearside Headlamp not working on dipped beam (1.7.5a)