1998 Volkswagen Golf

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sills (6.2.2 (d) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pipe corroded, covered in grease or other material BOTH SIDES (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security LOWER SILLS (6.2.2 (d) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake disc worn, pitted or scored, but not seriously weakened both front and rear (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake operation has insufficient reserve pressure/vacuum to provide assistance for at least four more brake applications after the warning device has operated (or gauge shows an unsafe reading) (1.1.3 (a) (i))

Braking system leaking vacuum leak (1.1.3 (d))

Nearside Front Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Brake pipe excessively corroded front to rear pipe (1.1.11 (c))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Brake disc worn, pitted or scored, but not seriously weakened both front and rear (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

o/s front fog inop

plastic sill covers fitted

Emissions not tested (7.0)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.D.1)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Stop lamp not working (1.2.1b)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Headlamp aim too low (1.8)

Offside Parking brake mechanism/associated mounting prescribed area is excessively corroded (3.1.9)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

o/s front fog inop

plastic sill covers fitted

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Lower Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Rear Shock absorber has negligible damping effect (2.7.5)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Shock absorber has negligible damping effect (2.7.5)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Body has slight corrosion (6.1.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp aim too low (1.8)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Headlamp aim too low (1.8)