1997 Toyota Land Cruiser

numerous other areas of underbody and chassis rusting / previously repaired and all covered in thick underseal

play in steering rack mounting rubbers

rear lower crossmember area badly rusting through

Nearside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Seat belt anchorage prescribed area strength or continuity significantly reduced extensive corrosion to rear of near side inner sill area (7.1.1 (a) (i))

Seat belt anchorage prescribed area strength or continuity significantly reduced extensive corrosion to rear of off side inner sill area (7.1.1 (a) (i))

Seat belt anchorage prescribed area strength or continuity significantly reduced off side rear inner wheel arch area rusted through in numerous areas (7.1.1 (a) (i))

Seat belt anchorage prescribed area strength or continuity significantly reduced top of near side rear inner wheel arch area rusted through (7.1.1 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inside of near side mid chassis rail area rusted through next to suspension mount (5.3.6 (a) (i))

numerous other areas of underbody and chassis rusting / previously repaired and all covered in thick underseal

play in steering rack mounting rubbers

rear lower crossmember area badly rusting through

Offside centre inner sill area slight corrosion and holed outside criteria

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside centre inner sill area slight corrosion and holed outside criteria

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength a.r,b.mtg (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases center (6.1.2 (a))

Nearside Rear Vehicle structure strengthening plate or fastening so insecure that structural rigidity is seriously reduced (6.1.1 (b) (ii)) DANGEROUS

Offside Rear Vehicle structure strengthening plate or fastening so insecure that structural rigidity is seriously reduced (6.1.1 (b) (ii)) DANGEROUS

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Nail in tyre ()

Offside Rear Nail in tyre ()

slight play in rack mounts

Nearside Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Nail in tyre ()

Offside Rear Nail in tyre ()

slight play in rack mounts

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

slight play in both inner rack joints

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

slight play in both inner rack joints

Nearside Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Upper Brake pipe leaking (3.6.A.1) DANGEROUS

Rear Brake pad(s) wearing thin (3.5.1g)

nearside parking brake tight, working ok at time of test