2004 Toyota MR2

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Inner Wheel arch covered in expanding foam. Not possible to check condition of A post

Offside Rear Inner Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security floor (6.2.2 (d) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp incorrect colour (4.1.4 (a))

Offside Front Outer Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Headlamp incorrect colour (4.1.4 (a))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch not operating in accordance with the requirements (4.5.3 (a) (i))

Exhaust noisy (7.1.4)

vehicle unsealed

slight bind to o/s/f brake

slight blow from exhaust

suspension bushes worn

vehicle under body undersealed

corrosion to suspension components

vehicle under body undersealed

both front tyres wearing unevenly

vehicle under body covered in under seal

front tyres wearing edges

slight wear to rear suspension bushes

underbody heavily undersealed

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

o/s/f wheel slightly binding, underneath corroded, n/s/f tyre wearing on inner edge, airbag light on, inner sills, floor, chassis, inner wheel arches corroded, brake pipes surface rust,

Front registration plate missing (6.3.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside front brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear fog lamp not working (1.3.2b)

Rear registration plate font not substantially similar to the prescribed font (6.3.4d)

front brake application uneven (3.7.B.2)

Front registration plate insecure (6.3.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Parking brake lever defective so that it cannot be satisfactorily operated (3.1.3c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate with character(s) which are not the correct stroke width (6.3.4a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Rear brake disc excessively pitted (3.5.1h)

Registration plate lamp not working (1.1.5c)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)