1997 Mazda MX-5

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust mounting defective cotton reel (6.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust mounting defective cotton reel (6.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front fuel pipe corroded at clip chalked

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Front fuel pipe corroded at clip chalked

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Emissions not tested (8.2.1.2 (d))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Horn not working (1.6.2a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)