2004 Mazda Bongo

Offside Front Service brake binding but not excessively (1.2.1 (f))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill and outrigger (5.3.6 (a) (i))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Front Service brake binding but not excessively (1.2.1 (f))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Anti-roll bar linkage attachment bracket/mounting fractured (5.3.3 (b) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake performance not tested due to gearbox issues (1.2.1 (g))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Seat belt damaged (7.1.2 (b) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn d bushes (5.3.4 (a) (i))

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn d bush (5.3.4 (a) (i))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Rear fog lamp missing (1.3.2a)

Rear Registration plate lamp not working (1.1.C.1d)

Stop lamp not working (1.2.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)