1997 Subaru Forester

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Steering rack gaiter split (2.2.D.2d)

Rear fog lamp missing (1.3.2a)

Clutch fluid is bellow 'MIN' level.

Engine oil level was very low (1.5L oil added)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside front tyre has its inner edge worn.

Oil leak

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

o/s/f headlamp has a chip

rear axel arms front bush slight play (o/s/r and n/s/r

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

o/s/f headlamp has a chip

rear axel arm front bush has slight play

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside front tyre has a cut.

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

n/side rear light lens cracked

o/side h/lamp stone chipped

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Nearside Rear Registration plate lamp flickers when tapped lightly by hand (1.1.5e)

Nearside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Upper Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Front Lower Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Upper Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Upper Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Upper Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)