1998 Ford Ka

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both rear tyres starting to perish on side walls

Front Exhaust system not adequately supported (7.1.1)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both rear tyres starting to perish on side walls

Front Exhaust system not adequately supported (7.1.1)

Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both rear tyres perished ;

nearside and offside front of floorpan corroded ;both front brake hoses perished ;

offside rear chassis leg corroded ;

offside rear tyre silghtly perished

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Upper Body has slight corrosion (6.1.B.2)

offside rear tyre silghtly perished

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front registration plate delaminated (6.3.1d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

NS sill weak with corrosion.

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear registration plate deteriorated (6.3.1d)