2000 Nissan Micra

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end/inner arch (5.3.6 (a) (i))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Power steering fluid level below minimum (2.1.5 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Tyre slightly damaged/cracking or perishing Both front (5.2.3 (d) (ii))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Off side inner sill at rear (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Off side outer sill at rear (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Off side rear inner sill backing (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Tyre slightly damaged/cracking or perishing Both front (5.2.3 (d) (ii))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

engine MIL illuminated

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

engine management light on

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Stop lamp not working (1.2.1b)

Offside rear brake binding (3.7.B.1)