1997 Mazda MX-3

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings Inner wing repair patch (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Lower Tie bar/rod has slight play in a pin/bush rear bush (2.4.G.2)

exhaust shield loose

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Both rear tyres worn on inner edges

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside rear brake binding (3.7.B.1)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front front brake binding (3.7.B.1)

Registration plate lamp not fitted (1.1.C.1b)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Front front brake binding (3.7.B.1)

slight blow from exhaust system

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Stop lamp not working (1.2.1b)

Rear brake disc excessively pitted (3.5.1h)

Registration plate lamp not working (1.1.5c)

Tyre incorrectly seated on the wheel rim (4.1.D.1d)