2003 Kia Sorento

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Coil spring corroded all (5.3.1 (b) (i))

Coolant leak ()

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Inner panel corroded

Offside Rear Inner sill corroded

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Brake pipe inadequately clipped or supported front to rear (1.1.11 (d) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Spare tyre defective ()

offside under sill corroded just outside perscribed area

Anti-roll bar pin or bush worn but not resulting in excessive movement both front d bushes (5.3.4 (a) (i))

nearside rear body mounting corroded

offside rear under sill corroded ,just outside seat belt prescribed area

Anti-roll bar pin or bush worn but not resulting in excessive movement both front d bushes (5.3.4 (a) (i))

Offside Position lamp not working (4.2.1 (a))

nearside rear body mounting corroded

offside rear under sill corroded ,just outside seat belt prescribed area

Nearside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Parking brake: efficiency below requirements (3.7.C.1b)

Seat belt anchorage prescribed area is inadequately repaired both nearside and offside under sill patches not fully seam welded (5.2.6)

rear crossmember corroded above tank mounting

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Parking brake efficiency below requirements (3.7.E.1)

Front registration plate character(s) laid out in an incorrect format (6.3.4f)

Front registration plate displaying a honeycomb or similar effect background (6.3.3)

Nearside Rear Anti-roll bar linkage insecure (2.4.G.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Rear registration plate character(s) laid out in an incorrect format (6.3.4f)

Rear registration plate displaying a honeycomb or similar effect background (6.3.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Upper Suspension arm attachment bracket/mounting corroded and its strength is seriously reduced (2.4.G.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Nearside Rear Anti-roll bar linkage severely distorted (2.4.G.1)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp aim too low (1.8)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Parking brake lever has no reserve travel (3.1.6b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

Offside Rear Brake pipe excessively corroded (3.6.B.2c) DANGEROUS

Parking brake: efficiency below requirements (3.7.C.1b) DANGEROUS

Nearside Inner Front Brake pipe slightly corroded (3.6.B.2c)

Offside Inner Front Brake pipe slightly corroded (3.6.B.2c)

Front registration plate character(s) laid out in an incorrect format (6.3.4f)

Front registration plate displaying a honeycomb or similar effect background (6.3.3)

Rear registration plate character(s) laid out in an incorrect format (6.3.4f)

Rear registration plate displaying a honeycomb or similar effect background (6.3.3)

Nearside Inner Front Brake pipe slightly corroded (3.6.B.2c)

Offside Inner Front Brake pipe slightly corroded (3.6.B.2c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Rear registration plate margin less than the minimum requirement (6.3.4g)

registration plate displaying a honeycomb or similar effect background (6.3.3)

registration plate not displaying a BSAU 145d marking (6.3.3b)

registration plate not displaying the name of the supplying outlet (6.3.3a)

registration plate not displaying the postcode of the supplying outlet (6.3.3a)

Offside Front Brake pad(s) wearing thin (3.5.1g)