2008 Nissan Skyline

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Offside Rear Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Emissions not tested ex blowing (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases rear silencer blowing (6.1.2 (a))

Headlamp deteriorated but light output not reduced both sides (1.7.5a)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Headlamp aim too low (1.8)

Registration plate lamp not working (1.1.C.1d)

Rear Registration plate lamp not working (1.1.C.1d)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)