1998 Fiat Coupe

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Headlamp aim too low (1.8)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Rear Brake load sensing valve linkage stiff (3.6.E.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s/f a.b.s wire bracket insecure.

slight corrosion on other main brake pipe.

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rear coil springs corroded.

slight deterioration on o/s & n/s front brake hoses.

some bulbs in high level stop not working.

some corrosion on rear brake pipes.

Brake load sensing valve linkage obviously incorrectly adjusted (3.6.E.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside rear brake recording little or no effort (3.7.B.5a)

Brake pipe slightly corroded (3.6.B.2c)

engine cover fitted † †bonnet gas rams faulty

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Brake pad(s) wearing thin (3.5.1g)