2007 Honda Accord

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Engine and sill covers fitted

Front Suspension arm pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Offside Front Outer Tyre has a cut but not deep enough to reach the ply or cords Wall also worn on edges (5.2.3 (d) (i))

Offside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Engine and sill covers fitted

Front Suspension arm pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Offside Front Outer Tyre has a cut but not deep enough to reach the ply or cords Wall also worn on edges (5.2.3 (d) (i))

Offside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

sill covers and engine cover fitted

Brake lever has insufficient reserve travel (1.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, but not excessively both (1.1.14 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

sill covers and engine cover fitted

Engine and sill covers fitted

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre worn close to legal limit/worn on edge Both worn on edges (5.2.3 (e))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front tyre walls cut [no cord showing]

engine cover and under trays fitted

sill covers fitted

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Nearside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pad(s) wearing thin (3.5.1g)

both front tyre walls cut [no cord showing]

engine cover and under trays fitted

sill covers fitted

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit & chunk missing out side wall (4.1.E.1)

engine management light on

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit & chunk missing out side wall (4.1.E.1)

engine management light on

Brake pedal anti slip rubber worn.

Clutch pedal anti slip rubber worn.

Front registration plate deteriorated (6.3.1d)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)