2005 Mazda 6

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Passenger seat(s) missing at time of test ()

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault airbag (7.1.6 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Passenger seat(s) missing at time of test ()

Front suspension ball joint dust cover damaged, but preventing the ingress of dirt both front upper (2.4.G.2)

brake fluid level is a little low

n/s number plate was not working at the start of the test but then started working and is still working

n/s/r antiroll bar drop link bushes are worn

rear exhaust joints quite rusty

Tyre worn close to the legal limit both front 3mm (4.1.E.1)

brake fluid level is a little low

child seats fitted too both rear seats unable too test seat belts

exhaust system is a little rusty

front brake pads are wearing low

both rear tyres are wearing low

child seats fitted both rear seats

dent in the o/s/r wheel arch

Rear Brake pad(s) wearing thin (3.5.1g)

Vehicle structure has slight corrosion (6.1.B.2)

winter tyres fitted to front of vehicle