2004 Mercedes-benz Slk

Nearside Front Inner Track rod end ball joint has slight play Rack end (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive rear floors (5.3.6 (a) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Lower Suspension arm ball joint excessively worn rear arm (5.3.4 (a) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Play in steering rack inner joint(s)

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Fuel pipe leaking (6.1.3 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Offside Front Lower Suspension arm ball joint likely to become detached rear of 2 arms (5.3.4 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush excessively worn Front of the 2 arms (5.3.4 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Front of the 2 arms (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Suspension arm attachment bracket/mounting corroded and seriously weakened Area of previous repair has missed this part. (5.3.3 (b) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement both lower arms (5.3.4 (a) (i))

Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

corrosion underside vehicle- front and rear suspension components, rear subframe

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel large imbalance (1.3.1 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Sub-frame corroded and seriously weakened in 3 places on upper arm box section factory welds (5.3.3 (b) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement both lower arms (5.3.4 (a) (i))

Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

corrosion underside vehicle- front and rear suspension components, rear subframe

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

parking brake slightly out of balance

surface corrosion underside vehicle

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front coil spring broken (2.4.C.1a)

Offside Front Headlamp aim too low (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear coil spring incomplete (2.4.C.1a)

Front brake disc slightly pitted (3.5.1h)

Lower Steering column universal joint has slight play (2.1.5)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)