2007 Subaru Forester

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Both sides sills holed (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Both sides behind wheel arches holed (5.3.6 (a) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge Worn edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Under body corrosion

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Under body (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases Centre flange (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened Heavily corroded (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive All 4 jacking points (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Outer Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Strut top housing (5.3.6 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Strut top housing (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Windscreen washer not working (3.5 (a))

Exhaust has a minor leak of exhaust gases Centre flange (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened Heavily corroded (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive All 4 jacking points (5.3.6 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Anti-roll bar attachment bracket/mounting fractured (5.3.3 (b) (ii)) DANGEROUS

Brake pad(s) wearing thin all (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Suspension component mounting prescribed area is corroded but not considered excessive all over (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge all (5.2.3 (e))

Emissions not tested (8.2.1.2 (d))

Exhaust fumes entering cabin (6.1.2 (b) (i))

Front Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Position lamp not working (4.2.1 (a) (ii))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Brake pipe excessively corroded next to tank (1.1.11 (c))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

Rear Exhaust silencer likely to become detached (8.1.1 (b) (ii)) DANGEROUS

Brake pad(s) wearing thin all (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Suspension component mounting prescribed area is corroded but not considered excessive all over (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge all (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Power steering fluid reservoir empty (2.1.5 (b) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear registration plate insecure (6.3.1b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Headlamp aim too high (1.8)