2006 Honda Jazz

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength undersill (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength strut turret (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength undersill (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive strut turret (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

nearside rear sill slightly corroded

Suspension component mounting prescribed area is corroded but not considered excessive advise front & rear suspension components slightly corroded (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material all brake pipes (1.1.11 (c))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

brake pipes coated in grease

Nearside Rear tyre showing 2 mm

Offside Front wishbone rear bush showing slight separation

brake pipes coated in grease

slight exhaust blow

brake pipes coated in grease

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

front and rear brake pads are low

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)