2013 Hyundai I20

Brake pipe corroded, covered in grease or other material Both sides rear (1.1.11 (c))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive Lower end (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Windscreen washer not working Both (3.5 (a))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps Both (4.7.2 (a))

Brake pipe corroded, covered in grease or other material Both sides rear (1.1.11 (c))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive Lower end (8.4.1 (a) (i))

Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Front Lower Suspension arm ball joint dust cover severely deteriorated osf and nsf both (5.3.4 (b) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Front Lower Suspension arm ball joint dust cover severely deteriorated osf and nsf both (5.3.4 (b) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)