2003 Fiat Doblo

Offside Front Shock absorbers has an excessively worn bush shocker top bush (5.3.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill corroded within 30cm of leaf spring mount (5.3.6 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords on inner wall (5.2.3 (d) (i))

Rear Brake pipe excessively corroded brake pipes on compensate valve corroded (1.1.11 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

3rd break light is no working

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

3rd break light is no working

Clutch pedal rubber missing

High level brake light not working

Offside front tyre scrubbing on outside edge

Rear Brake pipe slightly corroded x2 (3.6.B.2c)

High level brake light not working

LOW ENGINE OIL

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Ball joint has excessive play bottom (2.2.B.1f)

High level brake light not working

LOW ENGINE OIL

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Oil leak

Under-trays fitted obscuring some underside components

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Oil leak

Under-trays fitted obscuring some underside components

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

exhaust rear silencer - baffles breaking apart

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front disc pitted

Centre Stop lamp not working (1.2.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front disc pitted

Front discs slightly worn and pitted on inner face

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Exhaust system not adequately supported (7.1.1)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Parking brake lever, pawl mechanism pivots or their associated mountings are insecure (3.1.4b)

Front discs slightly worn and pitted on inner face

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp aim too high and too far to the left. (1.8)

Offside Registration plate lamp not working (1.1.5c)

Parking brake lever, pawl mechanism pivots or their associated mountings are insecure (3.1.4b)

Rear Exhaust system not adequately supported (7.1.1)

Rear Leaf spring has a deteriorated anchor pin rubber bush resulting in excessive movement (2.4.B.2)

Service brake: efficiency below requirements (3.7.B.7)

rear brake recording little or no effort (3.7.B.5a)

o/s/f tyre low inner edge

stains around fuel tank