2008 Honda Accord

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Both nearside and offside rear (5.3.6 (a) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Headlamp aim too low Both nearside and offside front (4.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Both nearside and offside rear (5.3.6 (a) (i))

general corrosion

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

general corrosion

general corrosion

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

general corrosion

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside headlamp mask fitted to headlamp

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside front tyre worn on inner edge

Both rear tyres are nearly bald on edges

Lower Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)