2006 Fiat Ducato

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear wheel arch corroded causing a hole within 20cm of a suspension mounting point (5.3.6 (a) (i))

Front radiator crossmember corroded

Front Coil spring corroded both (5.3.1 (b) (i))

Front Windscreen wiper blade defective (3.4 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced front and rear (6.1.1 (c) (i))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Nearside Front Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Offside Front Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing corroded around inspection hole at rear of sub-frame which has enlargened inspection hole . (5.3.6 (a) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength corroded and holed above sub-frame mounting . Note : brake pipe mounting plate needs to be removed and a plate seam welded behind pipe mounting to re-affix brake pipe mounting to . (5.3.6 (a) (i))

Front Direction indicator slightly discoloured both sides (4.4.3 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced general corrosion to underside (6.1.1 (c) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis leg above sub-frame mounting by brake pipe mounting is badly corroded . (5.3.6 (a) (i))

Rear both sides registration plate lamp lenses are dirty on inner and blocking light

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside front brake binding (3.7.B.1)

Offside front brake binding (3.7.B.1)

Front Headlamp aim too low and too far to the left. (1.8)

Both front tyre side walls starting to crack.

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Rear fog lamp not working (1.3.2b)