2008 Audi A5

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting repair covered in underseal outer and inner sill covered in filler/underseal to prevent inspection of repair (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material all covered in grease (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

brake pad warning lamp illuminated but plenty of pad wear left

under-trays fitted obscuring inspection of some underside components

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill corroded (7.1.1 (a) (i))

Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Both Sides front (5.3.4 (a) (i))

Nearside Front Tyre Got Cut

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Central exhaust clamps slightly deteriorated

Front Brake pad(s) wearing thin inners (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Central exhaust clamps slightly deteriorated

Front Brake pad(s) wearing thin inners (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

full under trays fitted at time of test

under trays fitted at time of test

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components