2007 Ford Ka

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush deteriorated (5.3.4 (a) (i))

Nearside Front Outer Road wheel slightly distorted (5.2.2 (c) (i))

hazard warning lamp tell tale not working

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt outer c.v gaiter split (6.1.7 (g) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength nearside rear inner sidesill excessively corroded (5.3.6 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively standard (3.4 (b) (ii))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength offside front inner sidesill excessively corroded[perferated] (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush deteriorated (5.3.4 (a) (i))

Nearside Front Outer Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

hazard warning lamp tell tale not working

FRONT EXHAUST FLEX DETERIORATED

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive SILL (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive WING AROUND FILLER NECK (5.3.6 (a) (i))

Offside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive WING (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced FLOOR RAIL (6.1.1 (c) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill by rear axle mount (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill by rear axel mount (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill by rear axle mount (5.3.6 (a) (i))

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)