2003 Mazda Bongo

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

advise --- service light on

both inner sills have bad surface corrosion advise wire brush and underseal before it gets any worse as this falls with in precribed areas (monator)

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Central Exhaust mounting defective (6.1.2 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

exhaust bracket loose

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Rear fog lamp does not emit a steady red light (4.5.4 (a))

exhaust bracket loose

both front tyres going bald outer edge + close to limit + n/s/f heavily perished

o/s/f wheel started to bind

Battery insecure (1.9.1)

Nearside front brake binding (3.7.B.1)

Rear fog lamp emits a light other than red (1.3.2e)

both front tyres going bald outer edge + close to limit + n/s/f heavily perished

o/s/f wheel started to bind

n/s/f tyre + n/s/r tyre both heavily perished

Nearside Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear fog lamp switch missing (1.3.1a)

Rear fog lamp missing (1.3.2a)

Rear fog lamp switch missing (1.3.1a)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)