2006 Toyota Aygo

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill area (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis in front of rear axle beam (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill area (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis in front of rear axle beam (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Rear Brake pipe leaking on a hydraulic braking system in front of rear axle beam (1.1.11 (b) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material in front of rear axle beam (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

rear axle beam corrosion

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement o/s and n/s (5.3.4 (a) (i))

Front Headlamp lens slightly defective o/s and n/s (4.1.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement o/s and n/s (5.3.4 (a) (i))

Front Headlamp lens slightly defective o/s and n/s (4.1.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength multiple areas (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front wiper smeary

Offside Rear tyre pressure low

Shock absorbers has slight external damage to the casing Both rear corroded (5.3.2 (b))

Nearside Rear Upper Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Upper Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

EML LIGHT ON

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Mechanical brake component has restricted free movement rear wheel seized / brake failing to release. (3.5.1k)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Central Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear unable to test wheel bearing due to wheel seized

Offside Rear metal brake pipe greased

Horn not working (1.6.2a)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

front brake discs worn

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)