2002 Jaguar Xj

MIL on

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis by subframe mounting (5.3.6 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive both inner sills (7.1.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced rear chassis (6.1.1 (c) (i))

advise corrosion on near side front wing

advise corrosion on rear wheel arches

advise exessive corrosion on both front jacking points

advise slight play in near side rear drive shaft

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive spring mounting (5.3.6 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive both inner sills (7.1.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive front subframe mountings (5.3.6 (a) (i))

advise corrosion on near side front wing

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe mounting (5.3.6 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Rear Fuel pipe leaking (6.1.3 (b) (i))

Anti-roll bar pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Seat belt anchorage prescribed area is corroded but not considered excessive both sills (7.1.1 (a) (i))

advise corrosion on all wheel arches

Anti-roll bar linkage pin or bush excessively worn both front (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear subframe and mounting plates (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Drive shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Suspension component mounting prescribed area is corroded but not considered excessive both inner sills (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive rear chassis (5.3.6 (a) (i))

advise corrosion on fuel lines

Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive both inner sills (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive rear chassis (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive rear subframe (5.3.6 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing/arch (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced arch (7.1.1 (a) (i))

Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

advise corrosion on underside

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mounting (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe mounting (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Drive shaft joint worn, but not excessively (6.1.7 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Drive shaft joint worn, but not excessively (6.1.7 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Nearside Front Vehicle structure has slight corrosion (6.1.A.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Headlamp aim too low (1.8)

Offside Front Steering rack gaiter split (2.2.D.2d)

Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Offside Steering rack gaiter split (2.2.D.2d)

oil low

Nail in nearside rear tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

Nearside Front Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust has part of the system slightly deteriorated (7.1.1a)