2006 Honda Accord

Front Outer Track rod end ball joint has slight play both sides (o/s and n/s) (2.1.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin both sides (o/s and n/s) (1.1.13 (a) (ii))

Rear Suspension spring mounting prescribed area damaged but not considered excessive both sides (o/s and n/s) (5.3.6 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both sides (o/s and n/s) (5.2.3 (e))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Inner Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake pedal anti-slip provision missing (1.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge very low 2mm (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge worn low 3mm (5.2.3 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Windscreen wiper blade defective insecure clip broken (3.4 (b) (i))

EML light on (engine misfire )

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Windscreen wiper blades worn /smear

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Registration plate lamp not working (1.1.C.1d)

EML light on (engine misfire )

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Windscreen wiper blades worn /smear

Nearside Front Tyre worn close to the legal limit Edges worn (4.1.E.1)

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit edges worn (4.1.E.1)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear tyre has a nail

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear tyre has a nail

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

offside rear brake disc signs of overheating

offside rear handbrake low performance compared to nearside

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)