2004 Subaru Legacy

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Headlamp lens slightly defective Both (4.1.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Body component damaged and likely to cause injury (6.2.1 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Headlamp lens slightly defective Both (4.1.1 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Body damage n/s/f

Offside Front Outer Tyre slightly damaged Sidewall (5.2.3 (d) (ii))

Body damage n/s/f

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Outer Tyre slightly damaged Sidewall (5.2.3 (d) (ii))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Outer Bumper insecure (6.1.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Lower near side / off side front lower arm back bushes worn

Nearside Front Front position lamp(s) has a product on the lens but not adversely affecting light output (1.1.A.3d)

Offside Front Front position lamp(s) has a product on the lens but not adversely affecting light output (1.1.A.3d)

Offside Front Lower Bumper insecure ()

Front registration plate deteriorated (6.3.1d)

Offside Rear Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords outer sidewall marked in yellow (4.1.D.1a)

Offside Rear Stop lamp not working (1.2.1b)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate deteriorated (6.3.1d)

Front Lower near side / off side front lower arm back bushes worn

Nearside Front Front position lamp(s) has a product on the lens but not adversely affecting light output (1.1.A.3d)

Offside Front Front position lamp(s) has a product on the lens but not adversely affecting light output (1.1.A.3d)

Offside Front Lower Bumper insecure ()

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front bumper insecure

Offside Headlamp aim too low (1.8)

Nearside Rear Tyre worn close to the legal limit outer edge worn and cut on inner wall!!! (4.1.E.1)

Nearside Front Brake pad(s) less than 1.5 mm thick recommend discs replaced same time (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit outer edge worn and cut on inner wall!!! (4.1.E.1)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Offside Headlamp not working on main beam (1.7.5a)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp aim too high (1.8)

Offside Headlamp not working on dipped beam (1.7.5a)

Front brake disc slightly pitted (3.5.1h)