2006 Fiat Multipla

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust has a major leak of exhaust gases front joint (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Suspension component pin or bush excessively worn radius arm (5.3.4 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected subframe (5.3.6 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm inner edge 195/65x15 (5.2.3 (e)) DANGEROUS

Coil spring corroded all four (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

both outer sills corroded

both rear wheels leaning in

rear subframe corroded

underside corroded

both front struts corroded

front subframe corroded

rear subframe corroded and welded

Nearside Rear Tyre tread depth below requirements of 1.6mm inner edge 195/65x15 (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

rear parking (secondary) brakes imbalanced 62% o/s reading low (3.7.B.6b)

both front struts corroded

front subframe corroded

rear subframe corroded and welded

both front struts corroded

front subframe corroded

rear subframe corroded and welded

Battery insecure (1.9.1)

Exhaust has a major leak of exhaust gases centre silencer (7.1.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm inner edge (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension spring mounting prescribed area is excessively corroded around bump stop (2.4.A.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside front brake excessively fluctuating (3.7.B.3)

brake disc in such a condition that it is seriously weakened both front (3.5.1i)

Front Brake pad(s) wearing thin (3.5.1g)

both front suspension struts corroded

front and rear coil springs corroded

front sub frame corroded

rear axle corroded

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Electrical wiring insecure (1.9.2a)

Nearside Headlamp aim too high (1.8)

Offside Rear Seat belt damaged sufficient to significantly weakened the webbing (5.2.2a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Suspension arm has excessive play in a pin/bush (2.4.G.2)

Battery insecure (1.9.1) DANGEROUS

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Direction indicators slightly discoloured (1.4.A.2f)

Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both outer sills covered

Battery insecure (1.9.1)

Nearside Rear Brake cable has restricted free movement (3.5.1k)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Headlamp aim too low (1.8)

Offside Rear Brake cable has restricted free movement (3.5.1k)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

rear parking (secondary) brakes imbalanced (3.7.B.6b) DANGEROUS

Brake cable has wires broken but is not significantly weakened (3.5.1b)

Rear Direction indicators slightly discoloured (1.4.A.2f)

Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both outer sills covered

Engine covers fitted obscuring some components in the engine bay

Battery insecure (1.9.1)

Offside Headlamp aim too high (1.8)

Offside Stop lamp not working (1.2.1b)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Engine covers fitted obscuring some components in the engine bay

Items removed from driver's view prior to test

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tie bar/rod ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Front Tie bar/rod ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Lower Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Lower Radius arm has excessive play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Offside Stop lamp remains on when the brakes are released (1.2.1e)

Offside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Upper Stop lamp remains on when the brakes are released (1.2.1e)

Brake pad warning wiring hanging loose on N/S/F hub assembily

Centre Front Seat belt stitching slightly frayed (5.2.2b)