2007 Honda Accord

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Nearside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner wing (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner wing (5.3.6 (a) (i))

inner wheel arch lining fitted

outer sill covers fitted

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

inner door sills starting to corrode

n/s/r tyre starting to wear uneven

outer sill covers fitted

Offside Rear wearing uneven inner edge

o/s/r brake slightly binding

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside engine mounting deteriorated, but not resulting in excessive movement (6.1.D.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Headlamp aim too high (1.8)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside engine mounting deteriorated, but not resulting in excessive movement (6.1.D.1a)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)