2009 Alfa Romeo 159

Electronic stability control warning lamp indicates a fault (7.12 (e))

Front Brake performance unable to be tested unsafe do to suspension failure (1.2.1 (g))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear Brake performance unable to be tested unsafe to test do to suspension arm possibly failure (1.2.1 (g))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Lower Suspension arm likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Offside Front Lower Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

rear exhaust shield under fuel tank excessively loose

Nearside Front Electrical wiring inadequately secured brake pad sensor (4.11 (a) (i))

Nearside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Brake disc worn, pitted or scored, but not seriously weakened Both rear (1.1.14 (a) (ii))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened Both rear (1.1.14 (a) (ii))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear lamp damaged

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Shock absorbers likely to become detached (5.3.2 (a) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear lamp damaged

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Exhaust emissions exceed manufacturer's specified limit limit 0.51 reading 0.93 (8.2.2.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Rear Suspension spring mounting prescribed area fractured significantly reducing structural strength cup on shock absorber (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Undertray likely to become detached (6.2.1 (a) (ii)) DANGEROUS

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Outer Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

brake sensor wires unplugged

fuel tank heat shield insecure

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Integral body structure is deformed but structural rigidity is not significantly reduced sill dented (6.1.1 (a) (i))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Nearside Front Tyre has ply or cords exposed below 1.6mm tread (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm and cuts to cord. (5.2.3 (e)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Integral body structure is deformed but structural rigidity is not significantly reduced sill dented (6.1.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front tyre worn smooth on inner edge

Offside Front tyre worn smooth on inner edge

engine cover and undertray fitted not allowing full inspection of some components

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front tyre worn smooth on inner edge

Offside Front tyre worn smooth on inner edge

engine cover and undertray fitted not allowing full inspection of some components

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Nearside Rear coil spring broken (2.4.C.1a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Outer Front Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components