2002 Toyota Land Cruiser

Shock absorbers has a reduced damping effect All four (5.3.2 (d))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre slightly damaged (5.2.3 (d) (ii))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tie rod has slight play

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Shock absorbers has a reduced damping effect All (5.3.2 (d))

All rear seats missing at time of test.

Front Wheel bearing has slight play Both. (5.1.3 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Both shocks have corrosion to casings.

All rear seats missing at time of test.

Front Wheel bearing has slight play Both. (5.1.3 (a) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Both shocks have corrosion to casings.

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front fog lamp not working

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Passenger seat(s) missing at time of test 3 x centre row , 2 x rear rear row

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

play in steering rack mounting bushes - not considered excessive

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Parking brake operation is causing the vehicle to swerve to the nearside (1.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Front wheel bearing has slight play (2.5.A.3c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear reflector missing (1.5.1a)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Rear Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

handbrake reserve travel poor

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not working on dipped beam (1.7.5a)