2008 Toyota Prius

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Coil spring corroded all (5.3.1 (b) (i))

Nearside Front headlamp has poor beam

both side sills and suspension mounting areas corroded

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Coil spring corroded all (5.3.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Chassis and inner sills corroded and covered with under seal front to rear (6.1.1 (c) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Under vehicle under sealed

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Coil spring corroded all (5.3.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced chassis and inner sills corroded and cover with under seal front to rear (6.1.1 (c) (i))

Nearside head light has poor beam condition

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Cross member has slight damage

Integral body structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Rear Coil spring corroded Both sides (5.3.1 (b) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Coil spring corroded all (5.3.1 (b) (i))

Front radiater cross member slightly damage

Rear Integral body structure is corroded but structural rigidity is not significantly reduced chassis and inner sills both sides (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Coil spring corroded all (5.3.1 (b) (i))

Rear suspension mounting area slightly corroded

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear axel bush slightly worn

Rear brake pads worn low

Rear suspension arm bush slightly worn both side

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

slight imbalance in front brakes

tested under wet conditions

Both front wipers split but still clearing the screen

Both front wipers split but still clearing the screen

Offside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)