2006 Iveco Daily

Fuel tank insecure (6.1.3 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust has a major leak of exhaust gases tail pipe (6.1.2 (a))

Horn not working (7.7 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Brake pedal wearing smooth (1.1.2 (c))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Power steering inoperative and steering adversely affected (2.1.5 (c) (ii)) DANGEROUS

Brake pedal wearing smooth (1.1.2 (c))

Nearside Direction indicator flashing more than 120 times a minute (4.4.4 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive out rigger (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive out rigger (5.3.6 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive out rigger (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive out rigger (5.3.6 (a) (i))

Horn not working (7.7 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength out rigger (5.3.6 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Horn not working (7.7 (a) (ii))

Nearside Rear Brake pad(s) contaminated (1.1.13 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outrigger (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outrigger (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement all rear anti roll bar bushes and links have slight play (2.4.G.2)

Nearside Front tyre has outer side wall damage close to limit

rear diff seal leak

Battery insecure (1.9.1)

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Brake pedal spongy (3.3.B.1b)

Horn sounds harsh or grating (1.6.2e)

Nearside Front Electrical wiring insecure behind wheel (1.9.2a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Mechanical brake component has restricted free movement wheel stiff to rotate (3.5.1k)

Parking brake: efficiency below requirements (3.7.B.7)

Trailer electrical socket (13 pin) not operating the trailer lamps as intended (1.9.4)

Trailer electrical socket deteriorated so that lead cannot be securely connected (1.9.3b)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement all rear anti roll bar bushes and links have slight play (2.4.G.2)

Nearside Front tyre has outer side wall damage close to limit

rear diff seal leak

Front Brake pad(s) wearing thin (3.5.1g)

Rear Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front discs worn

offside rear bump stop missing

Brake fluid warning lamp illuminated (3.6.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front discs worn

offside rear bump stop missing

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

N/S/F and O/S/R brakes grabbing slightly

Nearside Front Shock absorber has a light misting of oil (2.7.3)

REAR exhaust tailpipe deterioated

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

clutch pedal rubber missing

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

clutch pedal rubber missing