2008 Renault Master

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Fluid leak, but not excessive power steering (8.4.1 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Horn not working (1.6.2a)

Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen (1.8.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Upper Front suspension has slight movement at a suspension ball joint (2.5.A.1c)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

rear parking brake recording little or no effort (3.7.B.6a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

oil leak

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)