1999 Ford Focus

Nearside Front front brake binding (3.7.B.1)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded floor to sill (2.4.A.3)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Offside Stop lamp not working (1.2.1b)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' dirty (8.3.1e)

o/s front tyre near legal limit

plastic sill covers fitted at time of test

1. Head lamp beam patterns. 2. Unable to inspect outer sills fully due to plastic sill covers. 3. Nearside front tyre wearing low on edges. 4. Offside front tyre wearing low on inside edge.

5. Nearside rear tyre side wall starting to perish. 6. Hand brake travel on limit.

Offside Front Anti-roll bar linkage fractured (2.4.G.1)

1. Head lamp beam patterns. 2. Unable to inspect outer sills fully due to plastic sill covers. 3. Nearside front tyre wearing low on edges. 4. Offside front tyre wearing low on inside edge.

5. Nearside rear tyre side wall starting to perish. 6. Hand brake travel on limit.

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

rear section of exhaust slightly deteriorated

unable to inspect outer sills due to sill covers fitted

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Outer Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Offside Outer Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear coil spring broken (2.4.C.1a)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

mis fire on engine

rear section of exhaust slightly deteriorated

unable to inspect outer sills due to sill covers fitted

Emissions not tested (7.0)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

sills covers

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Inner Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

front brake discs in poor condition

headlamp lenses in poor condition

sill covers

Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Inner Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

front brake discs in poor condition

headlamp lenses in poor condition

sill covers

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

headlamp lenses in poor condition

sill covers

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

headlamp lenses in poor condition

sill covers

Headlamp damaged but light output not reduced (1.7.5a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

slight noise from n/s/r wheel bearing

Nearside Registration plate lamp not working (1.1.5c)

Offside Rear fog lamp not working (1.3.2b)

Offside Stop lamp not working (1.2.1b)

Headlamp damaged but light output not reduced (1.7.5a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

slight noise from n/s/r wheel bearing

front tierod ball joint boots split

n/s/r number plate light needs replacing

Nearside Registration plate lamp not working (1.1.5c)

Offside Front All position lamps not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front tierod ball joint boots split

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

centen exhaust silener becoming weak due to corrosion