2008 Mazda Bongo

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Front Service brake lagging in operation (1.2.1 (d))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch (6.1.1 (c) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Body component slightly loose exhaust heat shield (6.2.1 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Coolant leak

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Coolant leak

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength Cross member (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Nail in tyre

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Nail in tyre

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Offside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Cross member (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer 2 holes (6.1.1 (c) (i))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting cross member (6.2.2 (d) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Exhaust carbon monoxide content at idle exceeds default limits was 10.83 should be under 3.50 (8.2.1.2 (b))

Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch (6.2.2 (d) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced slam panel (6.1.1 (c) (i))

Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch x2 holes (6.2.2 (d) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced middle inner sill (6.1.1 (c) (i))

Offside Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security wheel arch (6.2.2 (d) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Play in steering rack inner joint(s)

Offside Front Inner Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Lower Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Steering rack gaiter split (2.2.D.2d)

Nearside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Lower Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Rear fog lamp not working (1.3.2b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)