2009 Mazda Bongo Friendee

Headlamp light source and lamp not compatible led bulbs fitted to both headlights (4.1.4 (c))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill to floor both sides (5.3.6 (a) (i))

Vehicle undersealed

Nearside Inner sill corroded

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Outer sill corroded.

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Inner sill corroded

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Outer sill corroded.

Nearside Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill corroded (6.1.1 (c) (i))

Nearside Rear Exhaust mounting defective missing rubber (6.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing Perished (5.2.3 (d) (ii))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security inner sill and out rigger (6.2.2 (d) (i))

Offside Front Tyre slightly damaged/cracking or perishing Perished (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing Perished and 3.5 mm (5.2.3 (d) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced Cross member holed (6.1.1 (c) (i))

Tyre slightly damaged Both front tyres some wear to outer edges (5.2.3 (d) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember (6.1.1 (c) (i))

Both rear inner wheel arches corroded at front section.

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Central Exhaust has a minor leak of exhaust gases section (6.1.2 (a))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill small hole (6.1.1 (c) (i))

Offside Rear Outer sill showing signs of corrosion.

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Vehicle structure inadequately repaired seriously affecting its strength within 30cm of towbar mounting Corrosion been covered over with alloy tape and under sealed over top (6.6.6) DANGEROUS

Advise corrosion to exhaust system

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Advise corrosion to exhaust system

Front registration plate missing (6.3.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill to floor (2.4.A.3)

Rear registration plate missing (6.3.1a)

Nearside Indicator tell tale inoperative (1.4.A.2a)

Nearside Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)