1998 Rover 416

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush excessively worn trailing (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced door shut (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced door shut/arch (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (7.1.1 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn trailing (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both front floors (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner sills (2.4.A.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Suspension component mounting prescribed area is corroded but not considered excessive both front floors (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner sills (2.4.A.3)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated (6.3.1d)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Seat belt anchorage prescribed area is excessively corroded door shut (5.2.6)

Nearside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded arch (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded door shut (5.2.6)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is excessively corroded arch (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

both front floor pans starting to corrode.

Brake pipe excessively corroded (3.6.B.2c)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too low (1.8)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both front floor pans starting to corrode.

Brake pipe slightly corroded (3.6.B.2c)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Fuel pipe/s corroded

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

nearside parking brake reduced effect

offside front tyre wearing inner edge

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Brake pipe slightly corroded (3.6.B.2c)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Fuel pipe/s corroded

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

nearside parking brake reduced effect

offside front tyre wearing inner edge

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

nearside parking brake reduced effect

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

nearside parking brake reduced effect

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front coil springs starting to corrode, Plastic covers over outer sills, Nail in o/s/r tyre tread, Rear radius arm bushes split, n/s/f tyre slightly out of shape.

Strongly adv, Full brake inspection, Suspect front and rear brake pads low, Front tyres worn inner tread and close to legal limit, Front brake pipes starting to corrode, Tracking check, Corrosion n/s/f and o/s/f floor,

Offside Outer Front Front constant velocity joint gaiter split (2.5.C.1a)

Strongly adv, Full brake inspection, Hand brake travel, Front tyres worn inner tread, Tracking check, Corrosion n/s/f and o/s/f floor, Plastic covers over outer sills, Nail in o/s/r tyre tread, Rear radius arm bushes split.

Strongly Adv, Full brake inspection, Rear radius arms, bushes split, Plastic covers over outer sills, Tracking check,Front number plate worn, Front tyres worn unevenly.

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim too high and too far to the right. (1.8)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Strongly Adv, Full brake inspection, Rear radius arms, bushes split, Plastic covers over outer sills, Tracking check,Front number plate worn, Front tyres worn unevenly.

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Rear Parking brake lever has no reserve travel (3.1.6b)

both front tyres wearing on inner edges