2006 Honda S2000

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill area (6.1.1 (c) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Boot lid cannot be secured in the closed position (6.2.1 (e))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement D Bushes Both Sides (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Nail in tyre

Offside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement partial separation at rear bush (2.4.G.2)

Nearside Rear Upper Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)