2013 Seat Leon

Exhaust has a minor leak of exhaust gases At back box join. Also badly corroded. (6.1.2 (a))

Fuel cap seal ring cracked.

Nearside Rear Nail in tyre ()

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

fuel cap seal perished

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Headlamp aim too high (4.1.2 (a))

Offside Front Suspension arm pin or bush likely to become detached arm rear most bush (5.3.4 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases rear pipe into rear most silencer weld cracked/splitting (6.1.2 (a))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Front Brake disc worn, but not excessively both (1.1.14 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear exhaust heatshield insecure

Front Brake disc worn, but not excessively both (1.1.14 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear exhaust heatshield insecure

under trays fitted

Front Brake pad(s) wearing thin both (1.1.13 (a) (ii))

under trays fitted

Front Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

under trays fitted

Nearside Front Tyre worn close to the legal limit 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit 1.6mm (4.1.E.1)