1998 Mazda 121

Centre Rear Stop lamp remains on when the brakes are released (1.2.1e)

Nearside Rear Stop lamp remains on when the brakes are released (1.2.1e)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Stop lamp remains on when the brakes are released (1.2.1e)

Offside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Rear Exhaust system not adequately supported (7.1.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake lining(s) wearing thin (3.5.1g)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front and rear prescribed areas all heavily corroded

front brake discs corroded

interior mirror missing

offside front outer brake pad very low

spare wheel carrier not fitted

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front Brake lining(s) wearing thin (3.5.1g)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

front brake discs very worn and corroded

front floors, rear inner sills and outer sills corroded

interior mirror not fitted

offside front outer brake pad lining very low

spare wheel carrier not fitted

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Front Brake pad(s) wearing thin (3.5.1g)

both front discs worn

interior mirror missing

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front coil spring incomplete (2.4.C.1a)

Nearside Rear Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Rear Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Rear Passenger's seat insecure (6.2.A.1)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Temporary fuel cap fitted

crack on front number plate

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Front front brake juddering slightly (3.7.A.2b)

Nearside Rear Upper Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Upper Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Rear Upper Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

advise slight play in rear axle busges.

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside front brake juddering severely (3.7.A.2b)

Offside Front front brake juddering severely (3.7.A.2b)

Offside rear brake recording little or no effort (3.7.B.5a)

front brake application uneven (3.7.B.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)